Prev Page Next Page

Procedural Continuous Assignments

Formal Definition

Procedural continuous assignments provide a means to continuously drive a value into a register or a net.

Simplified Syntax

assign register_assignment ;
deassign register_left_value ;
force register_assignment | net_assignment ;
release register_left_value | net_left_value ;
register_left_value - left hand-side operand ;
net_left_value - left hand-side operand ;


In the assign statement, the left hand-side operand can be a register or a concatenation of registers in contrast to continuous assignments where the left hand-side operands are nets. However, the memory word, bit-select or part-select cannot be used on the left hand-side. The priority of procedural continuous assignment is higher than that of the procedural assignments. The deassign keyword informs the end of the driving of the corresponding register. After a deassign, register values remain the same until driven by another procedural or procedural continuous assignment. If the assign keyword is used a second time for the same register, the first register will be deassigned and a new procedural continuous assignment statement takes place.

The keywords force and release have the same effect as assign and deassign; however the left hand-side operand should be a net or a bit-select or a part-select of vector net or concatenation of both. It cannot be part-select or bit-select of a vector register or a memory word.

An assign declared as a force overrides all procedural assignments to the register until the release statement is executed. In the same way, if a net is driven by a procedural continuous assignment all previous assignments are overridden until the release statement is executed. In the register case, the value will be maintained to the next procedural continuous assignment.


Example 1

module example1(clk, d, reset, set, q) ;
input clk, d, reset, set;
output q;
reg q;
  always @(posedge clk) q = d;
  always @(reset or set) begin
  if (reset) assign q = 1'b0;
  else if (set) assign q= 1'b1;
  else deassign q;

Important Notes

Prev Page Next Page
Powered by IXwebhosting